More work than Photos (Seat Teaser!) ROUND3! FIGHT! Friday 01 April, 2011

Covered in this will by my work on the fuel system and discussing what is left to do and needing purchased yet. (Click Read more to Continue reading not the image, I know it sucks…) Work Accomplished today: Finished Soldering on connections for both the Fuel Pump and Fuel Sender. Installed new Fuel pump Strainer […]

Covered in this will by my work on the fuel system and discussing what is left to do and needing purchased yet.

(Click Read more to Continue reading not the image, I know it sucks…)

Work Accomplished today:

Finished Soldering on connections for both the Fuel Pump and Fuel Sender.

Installed new Fuel pump Strainer as well as Fuel pump on the Hanger.

Installed Fuel Pump Hanger!

Photos Of these Said Accomplishments…\

I do not have photos of this but, I also isntalled the fuel tank and loaded it with 2 gallons of fuel. And test ran the pump. Had a few leaks I clamped down. Oddly enough 2 were in the return line. I got all but one leak taken care of and I need to buy a Metric to AN fitting to take care of this properly. After that I should be good there.

I also Attached my PermaCool that I had mounted on my supra to the radiator of the corolla. This thing MOVES air. So no cooling issues should be had. Also picked up an adjustable fan controller from Autozone today. Need to start working on the circuit for this/buy a 30amp relay.

CXRacing Aluminum Radiator.

Adjustable Fan Controller.

I also need to start the circuit for my Fuelpump/buy a 30amp relay.

And the wiring for my alternator as I am using an alternator from a supra it has different connections. No biggie I have to extend the harness as is to reach the across the engine.

Need to have a bung welded on for my Coolant Temperature probe on my Yashio Factory Gauge.

And find Brass adapter fittings for the ECU Coolant Temperature probe (otherwise my VVTI won’t work!). And that would make me a sad panda.

So a bunch of small things on Fuel, Coolant, And charge system are left.

Then the non-vital items but definitely important, my gauges Oil Pressure, Oil Temp, Tachometer, Coolant Temp, Vacuum Gauge all need wired into a harness that will be plugged in for lighting and sending wires.

Need to Start welding up my Seat rail as well. Which reminds me here is a teaser pic of the recovered seat almost complete.

***Please note I threw the over on really quick. And it doesn’t have the harness holes cut of the outer wire to snug the over on. So it’s just kind of sitting on there. But you can start to get a good idea of the Colour scheme from the photos. Really Coming together (Thanks, Mom!)

That’s all I can think of at the moment. New post this weekend hopefully? Looking like won’t be able to paint the new rims until sometime mid-late next week. So be  ready for that shit! Thanks again for ready everybody!

-Ryan

There are no comments yet, add one below.

Leave a Comment


Leave a Reply

Your email address will not be published. Required fields are marked *